![]() ![]() Mounting height is the same for an electrical switch, 48" on center. Select the appropriate location for the 212iLM Mullion. You will need a drill, drill bits1/8, 3/16 & 5/16 (for the plastic anchors), wire strippers, regular & small flat blade screwdrivers, a marking pen or pencil, some heat shrinkable tubing (for the wire splices), a ruler or measuring tape, silicone to seal any holes and possibly some electrical tape to hold the wires together or the template in place.Ģ12iLM Mullion Dimensions: 6 ½”L x 1 ¾”W x 1 1/8”D Taking this inventory will familiarize you with the components as well as ensure that you have a complete parts list. Please check the contents of this package and verify all components in the packing list are present. Literature: (1) 212 Standalone Mullion Instruction Manual Hardware: (1) Hardware Pack containing: (2) 8 x1¼” Panhead Slotted Machine Screw (2) 8 x 1¼” Round Head Wood Screw (2) 6-8 x ¾” Plastic Anchor, (1) 212iLM mounting template. Keypad: (1) 212iLM Mullion keypad Harnesses: (1) 8 Conductor wire harness Wrenches: (1) Standard 5/64 allen wrench ![]() This warranty shall expire two years after shipping date for DOOR-GARD keypads.Įxcept as stated above, IEI makes no warranties, either express or implied, as to any matter whatsoever, including, without limitation to, the condition of its products, their merchantability, or fitness for any particular purpose.Q Section 1: Unpacking and checking the packing list IEI will not be liable to the purchaser or anyone else for incidental or consequential damages arising from any defect in, or malfunction of, its products. IEI’s sole liability is limited to the repair or (at IEI’s option) the replacement of the defective product or part when sent to IEI’s facility (freight and insurance charges prepaid), after first obtaining IEI’s Return Merchandise Authorization. IEI does not assume any responsibility for damage or injury to person or property due to improper care, storage, handling, abuse, misuse, normal wear and tear, or an act of God. (IEI) warrants its products to be free from defects in material and workmanship, when they have been installed in accordance with the manufacturer’s instructions, and have not been modified or tampered with. On SE keypad, holes have also been spotted inside the front housing for additional LEDs (LEDs not included).To speed installation of the SE keypad, holes have been spotted on the inside the back housing for mounting to a wall or a single-gang electrical box.For use in extreme weather conditions, consult the factory for additional methods of protecting your keypad.This allows air to circulate and a place for condensation to drain. Do not seal the drain holes at the bottom of the keypad housing.Do not silicone the cover plate because the unit will not seal properly. ![]() This helps prevent water from entering the case and condensing on the circuit board. When mounting this unit outside, apply silicone to the area where the wires enter the case.The bi-color LED provided with the SE keypad illuminates red when the LockRelease relay is de-energized and green when the relay is de-energized.To avoid ESD (Electro-Static Discharge) interfering with the operation of the keypad, ground the housing to earth ground. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |